NOTICE No: MT000000845 |
MODEL: Mazda MPV |
YEAR: 1989-1991 |
AFFECTED VINs: N/A |
SUBJECT: EC-AT 2-3 upshift chirp |
- DETAILS:
While driving, there is a metallic chirp noise occurring during the 2-3 upshift after the A/T is up to normal operating temperature.
This noise will occur while operating in the "D" range. The 4WD is the only model reported to have this condition at this time.
- Verify the concern is actually from the transmission.
- If the condition occurs, remove the oil pan to access the 2-3 band apply servo cover. Remove the cover (valve body removal is not necessary) and servo piston to gain access to the servo piston stem (P/N BV11-19-386). Check the stem for damage or excessive wear at both ends and replace if needed. Refer to WSM page K1-84 (1991 WSM) for specific location of piston stem.
|
- CONSUMER NOTICE:
- The information and instructions in this notice are intended for
use by skilled technicians. Mazda technicians utilize the proper
tools/equipment and take training to correctly and safely maintain
Mazda vehicles. These instructions should not be performed by
"do-it-yourselfers." Consumers should not assume this
notice applies to their vehicle or that their vehicle will develop
the described concern. To determine if the information applies,
consumers should contact their nearest authorized Mazda dealership.
|
|