MPVClub.com home Log in to check your private messages Support MPVClub.com!


MPVClub.com
Shop
Tech Info
TSBs
Repair Info
Recalls

Forum
Do-It-Yourself
Gallery
Aftermarket
Links
Members
Dealers
Tools
Handout Flyers
Contact
Page Hits: 1964402
US BULLETIN No: Q001/91 DATE: 1991
CAN BULLETIN No: N/A
APPLIES TO: 1991 MPV AFFECTED VINs: All
SUBJECT: Checking tire pressure during PDI
BULLETIN NOTES: Applicable to all 1991 models
DETAILS:

The factory over-inflates the tires so that flat-spots will not occur during transportation and storage. To prevent customer complaints of a harsh or stiff ride, inspect and adjust the tire pressures on all vehicles at PDI and once again just prior to customer delivery. The vehicle's certification label on the "B"-pillar (either on the door or the door jamb) lists the correct tire pressure.

TIRE PRESSURE (COLD)

Model Front Rear
323/Protege 32psi 32psi
626/MX-6 32psi 26psi
929/929S 30psi 30psi
MX-5 Miata 26psi 26psi
RX-7 32psi 32psi
Navajo 26psi 26psi
B-Series:
   4x2
   4x4

26psi
28psi

34psi
31psi
MPV:
   14 in Tire
   15 in Tire

35psi
32psi

35psi
32psi

NOTE: Excessive tire pressures can increase steering wheel vibration and effect overall ride of the vehicle.

CONSUMER NOTICE:
The information and instructions in this bulletin are intended for use by skilled technicians. Mazda technicians utilize the proper tools/equipment and take training to correctly and safely maintain Mazda vehicles. These instructions should not be performed by "do-it-yourselfers." Consumers should not assume this bulletin applies to their vehicle or that their vehicle will develop the described concern. To determine if the information applies, consumers should contact their nearest authorized Mazda dealership.
  Go Back